Annual tech inspection party.

[bimmertech]

We will be doing this Saturday, Feb 8th at Element Garage.

Please tell other drivers that may not visit the forums as often.

If your car is street legal it would be best if you could drive it as trailer parking is limited.

[Chuck Baader]

Out...too soon!

[DelanieC]

We will be doing this Saturday, Feb 8th....

Do you mean NEXT Saturday (two weeks from yesterday) Feb 8th? If so, I should be good if Kirk is done with my roll bar in the time estimated.

[bimmertech]

Do you mean NEXT Saturday (two weeks from yesterday) Feb 8th? If so, I should be good if Kirk is done with my roll bar in the time estimated.

Yes. February 8th, 2014. Get it done!

[jatow]

In for an annual. What time?

I'll be trailering, suggestions on parking?

[bimmertech]

Time is not set in stone but we should begin by 9am. There is room for a couple trailers as long as they park perpendicular to the shop near the road. it will only be an issue if five or six trailers show up at the same time.

[rodhx]

I'll be driving mine there, but could trailers park on the opposite side of the road and drive the cars over?

[kilgojr]

Yes, trailers could park across the street in a gravel lot. However, as Casey said, unless 6 trailers show up at once, it shouldn't be a problem.

If anyone needs any last minute items, let me know. We have a full service parts store at the shop now. I can order any TT items you need and have them ready for you.

[zukitek]

well once again Im out due to it being on a saturday that im on duty. Guess Ill wait till TGPR .

[bimmertech]

Do you mean NEXT Saturday (two weeks from yesterday) Feb 8th? If so, I should be good if Kirk is done with my roll bar in the time estimated.

Are you going to make it?

[DelanieC]

I'm still waiting on Kirk to finish my roll bar. His original estimate was last Friday but I fear Snowpocalypse may have delayed it. Once the roll bar is in my possession it's just a matter of bolting everything in and I'm ready to go! If I don't hear anything by Thursday I'll just post that I can't make it.

[87RX7RACER]

Would love to be there, but the Evo is still not back on the road and still doesn't have the bar installed yet. I will be getting tech'd at TGPR as well.

[bimmertech]

Updated first post. Rich will be there at 10am.

Delanie, hope you can make it. Just let me know so there will be enough log books.

Vince, I take it you haven't ordered a bar yet, or you just haven't installed it?

We still have plenty of room for more TT or club racers needing annuals.

[DelanieC]

It looks like I'm out. The bar has been built but it's been too cold to paint .... and it isn't getting any warmer.

[87RX7RACER]

I'm sure Mark will have to make one. Doubt he has one just laying around the shop for an Evo...

I'm going to try and at least come by and hang out. See everyone there!