I made a mistake on the miata

[Chuck Baader]

I would think most will be sized for a 2 1/4" or 2 1/2" ID spring. Either will work with the 2.5" springs. You want to make sure the "hat" that holds the top of the spring is sized correctly for the Koni shock shaft.

[Chuck Baader]

Check these out:

http://www.ebay.com/itm/Koni-30-0000-0005-Threaded-Spring-Perch-Sleeve-/111528964147?hash=item19f7a4f033&vxp=mtr

[engled]

Check these out:

http://www.ebay.com/itm/Koni-30-0000...a4f033&vxp=mtr

I think that part number is the sleeve only, no adjuster.

[rodhx]

My car had ebay sleeves. I recall the issue was more getting sleeves that fit the shock body, especially since the Konis are a smaller diameter. Lots of online talk about rubber o-rings to take up the slack.

The Bilsteins are bigger than the Konis so I got pointed to the an ebay set for a Celica that ended up fitting the shocks perfectly. No problem with 2.5" springs.

[Chuck Baader]

Call Jeg's and ask exactly what is included. The whole coil over setup is available for $80 on fleabay.

[zukitek]

Thanks everyone for all the help! I got the springs and should have the shocks by monday. Ill choose some sleeves , adjusters ,and hats after that.

[zukitek]

Call Jeg's and ask exactly what is included. The whole coil over setup is available for $80 on fleabay.

You got a link on that $80 fleabay unit?

[engled]

You got a link on that $80 fleabay unit?

Ditto, I have never seen four koni sleeves and adjusters that cheap.

[engled]

Thanks everyone for all the help! I got the springs and should have the shocks by monday. Ill choose some sleeves , adjusters ,and hats after that.

NB hats are the cheap way to go. Would have been a little easier to start with NB shocks but if you didn't I have to hook for you.

[zukitek]

I found these http://www.kingmotorsports.com/p-214...h-sleeves.aspx and then they also had these http://www.kingmotorsports.com/p-214...h-sleeves.aspx WTH is the differance?

[rodhx]

That site isn't particularly helpful with the info on those. Maybe do a search for the two Koni parts numbers in those listings?

[Chuck Baader]

The ebay units were 80 each!

[slowautoxr]

I used cheap ebay sleeve/adjusters on the front of my RallyCross RX-7 for a long time. Included in the kit were some orings that took up the space between the strut body and the ID of the sleeve. I never had an issue with them.

[zukitek]

I ended up ordering http://www.summitracing.com/parts/aaf-all64146

They are for a 2 inch o.d. shocks and my shocks are 1.6 inch od but Im sure that wont be a problem in the case.