Tweet
All of these items have less than 1000 miles on them:
new timing belt, water pump, belt tensioner and all belts
new competition motor mounts
new ACT clutch and pressure plate, flywheel was also resurfaced when clutch was installed
new Russell stainless steel brake lines
new 949 Racing adjustable endlinks
new Racing Beat 1-1/4" hollow sway bar
new endlink frame attachment point reinforcement plate
new high dollar silicone plug wires, do not remember name of manufacturer
new NGK iridium spark plugs
new Tanabe front shock tower brace
new ISC Racing cold air intake
new clutch slave cylinder and master cylinder and clutch stainless steel line
new Kirk Racing roll bar with door bars
new Racing Beat 4into1 stainless steel header with header wrap and Racing Beat exhaust from cat back and a Flowmaster high flow cat
new OEM Mazda O2 sensors, both of them
Apexi piggyback air/fuel controller
new crank position sensor
good top with glass window
new Simpson 5 point harness
new Mishimoto silicone radiator hoses
new aluminum underdrive pulleys on alternator and power steering
new EBC Green brake pads on front and Hawk Plus pads on rear
new control arm alignment bolts
new Orange 3M wrap on body
new tie rod ends
aftermarket wheels with decent tires
Redline lube in transmission and diff and Mobil 1 synthetic in engine
Extra parts that go with car:
Momo steering wheel and horn button
ACT Ultralight flywheel, new in box
Lots of stock parts that were removed from car
short shifter
extra coil packs
welded rear diff and housing
used front bumper cover
extra set of 949 racing aluminum lug nuts
I'm sure there is more but that is all that comes to mind now. Car will need an alignment due to selling original control arms but should be able to get it close enough to drive. It has 137,000 miles on car and engine. I would like to get $3600 for car and all parts and pieces I have for car. The front bumper cover is damaged due to a small accident and the wrap is torn but it is serviceable. I have been driving it this way. That is why there is an extra front bumper cover I never installed. Let me know if you have any questions, 205-936-9449. I am located 2 hours west of Atlanta in Pell City, Alabama.
Thanks,
Roger
new timing belt, water pump, belt tensioner and all belts
new competition motor mounts
new ACT clutch and pressure plate, flywheel was also resurfaced when clutch was installed
new Russell stainless steel brake lines
new 949 Racing adjustable endlinks
new Racing Beat 1-1/4" hollow sway bar
new endlink frame attachment point reinforcement plate
new high dollar silicone plug wires, do not remember name of manufacturer
new NGK iridium spark plugs
new Tanabe front shock tower brace
new ISC Racing cold air intake
new clutch slave cylinder and master cylinder and clutch stainless steel line
new Kirk Racing roll bar with door bars
new Racing Beat 4into1 stainless steel header with header wrap and Racing Beat exhaust from cat back and a Flowmaster high flow cat
new OEM Mazda O2 sensors, both of them
Apexi piggyback air/fuel controller
new crank position sensor
good top with glass window
new Simpson 5 point harness
new Mishimoto silicone radiator hoses
new aluminum underdrive pulleys on alternator and power steering
new EBC Green brake pads on front and Hawk Plus pads on rear
new control arm alignment bolts
new Orange 3M wrap on body
new tie rod ends
aftermarket wheels with decent tires
Redline lube in transmission and diff and Mobil 1 synthetic in engine
Extra parts that go with car:
Momo steering wheel and horn button
ACT Ultralight flywheel, new in box
Lots of stock parts that were removed from car
short shifter
extra coil packs
welded rear diff and housing
used front bumper cover
extra set of 949 racing aluminum lug nuts
I'm sure there is more but that is all that comes to mind now. Car will need an alignment due to selling original control arms but should be able to get it close enough to drive. It has 137,000 miles on car and engine. I would like to get $3600 for car and all parts and pieces I have for car. The front bumper cover is damaged due to a small accident and the wrap is torn but it is serviceable. I have been driving it this way. That is why there is an extra front bumper cover I never installed. Let me know if you have any questions, 205-936-9449. I am located 2 hours west of Atlanta in Pell City, Alabama.
Thanks,
Roger
Comment